Cisco 5548 Arp Request Local Ip Address
I have a Nexus 5548UP trunked to a Catalyst 2960S. I have verified that spanning tree is working. I explicitly made the 2960S the root bridge for all VLANs as a temporary measure since it is trunked to an ASA for inter-VLAN routing (router on-a-stick).If I run debug ip arp event I get messages like the following: 2011 Dec 17 00:05 arp: arpprocessreceivepacketmsg: Destination address is not local 192.168.99.1 on Vlan99These are definitely coming across the trunk, but I would have figured that the ARP table would list the trunk port as the port for that entry. Imyfone lockwiper 2.5.0.5 crack. What does Destination address is not local mean?Why is my Nexus 5548UP not adding ARP entries for the trunk to a 2960S even though ARP frames are pas?
Arp Reply
An ARP probe is an ARP request constructed with an all-zero sender IP address. The term is used in the IPv4 Address Conflict Detection specification (RFC 5227). Before beginning to use an IPv4 address (whether received from manual configuration, DHCP, or some other means), a host implementing this specification must test to see if the address.